/*
* CDDL HEADER START
*
* The contents of this file are subject to the terms of the
* Common Development and Distribution License (the "License").
* You may not use this file except in compliance with the License.
*
* You can obtain a copy of the license at usr/src/OPENSOLARIS.LICENSE
* or http://www.opensolaris.org/os/licensing.
* See the License for the specific language governing permissions
* and limitations under the License.
*
* When distributing Covered Code, include this CDDL HEADER in each
* file and include the License file at usr/src/OPENSOLARIS.LICENSE.
* If applicable, add the following below this CDDL HEADER, with the
* fields enclosed by brackets "[]" replaced with your own identifying
* information: Portions Copyright [yyyy] [name of copyright owner]
*
* CDDL HEADER END
*/
/*
* Copyright 2009 Sun Microsystems, Inc. All rights reserved.
* Use is subject to license terms.
*/
/*
* PCI Express nexus driver tunables
*/
#include <sys/types.h>
#include <sys/ddi.h>
#include <sys/sunddi.h>
#include <sys/cmn_err.h>
#include <sys/time.h>
#include "px_obj.h"
/*LINTLIBRARY*/
uint32_t px_spurintr_duration = 60000000; /* One minute */
uint64_t px_spurintr_msgs = PX_SPURINTR_MSG_DEFAULT;
/*
* The following variable enables a workaround for the following obp bug:
*
* 1234181 - obp should set latency timer registers in pci
* configuration header
*
* Until this bug gets fixed in the obp, the following workaround should
* be enabled.
*/
uint_t px_set_latency_timer_register = 1;
/*
* The following driver parameters are defined as variables to allow
* patching for debugging and tuning. Flags that can be set on a per
* PBM basis are bit fields where the PBM device instance number maps
* to the bit position.
*/
uint_t px_mmu_error_intr_enable = (uint_t)-1;
uint_t px_rerun_disable = 0;
uint_t px_error_intr_enable = (uint_t)-1;
uint_t px_dwsync_disable = 0;
uint_t px_intsync_disable = 0;
uint_t px_intr_retry_intv = 5; /* for interrupt retry reg */
uint8_t px_latency_timer = 0x40; /* for pci latency timer reg */
uint_t px_panic_on_fatal_errors = 1; /* should be 1 at beta */
uint_t px_thermal_intr_fatal = 1; /* thermal interrupts fatal */
uint_t px_buserr_interrupt = 1; /* safari buserr interrupt */
uint_t px_ctx_no_active_flush = 0; /* cannot handle active ctx flush */
uint_t px_use_contexts = 1;
hrtime_t px_intrpend_timeout = 5ull * NANOSEC; /* 5 seconds in nanoseconds */
uint64_t px_perr_fatal = -1ull;
uint64_t px_serr_fatal = -1ull;
uint64_t px_errtrig_pa = 0x0;
char px_panic_hb_msg[] = " System bus";
char px_panic_rc_msg[] = " PCIe root complex";
char px_panic_rp_msg[] = " PCIe root port";
char px_panic_fab_msg[] = " PCIe fabric";
/*
* The following flag controls behavior of the ino handler routine
* when multiple interrupts are attached to a single ino. Typically
* this case would occur for the ino's assigned to the PCI bus slots
* with multi-function devices or bus bridges.
*
* Setting the flag to zero causes the ino handler routine to return
* after finding the first interrupt handler to claim the interrupt.
*
* Setting the flag to non-zero causes the ino handler routine to
* return after making one complete pass through the interrupt
* handlers.
*/
uint_t px_check_all_handlers = 1;
/*
* The following value is the number of consecutive unclaimed interrupts that
* will be tolerated for a particular ino_p before the interrupt is deemed to
* be jabbering and is blocked.
*/
uint_t px_unclaimed_intr_max = 20;
/*
* The following value will cause the nexus driver to block an ino after
* px_unclaimed_intr_max unclaimed interrupts have been seen. Setting this
* value to 0 will cause interrupts to never be blocked, no matter how many
* unclaimed interrupts are seen on a particular ino.
*/
uint_t px_unclaimed_intr_block = 1;
uint_t px_lock_tlb = 0;
uint64_t px_dvma_debug_on = 0;
uint64_t px_dvma_debug_off = 0;
uint32_t px_dvma_debug_rec = 512;
/*
* dvma address space allocation cache variables
*/
uint_t px_dvma_page_cache_entries = 0x200; /* # of chunks (1 << bits) */
uint_t px_dvma_page_cache_clustsz = 0x8; /* # of pages per chunk */
#ifdef PX_DMA_PROF
uint_t px_dvmaft_npages = 0; /* FT fail due npages */
uint_t px_dvmaft_limit = 0; /* FT fail due limits */
uint_t px_dvmaft_free = 0; /* FT free */
uint_t px_dvmaft_success = 0; /* FT success */
uint_t px_dvmaft_exhaust = 0; /* FT vmem fallback */
uint_t px_dvma_vmem_alloc = 0; /* vmem alloc */
uint_t px_dvma_vmem_xalloc = 0; /* vmem xalloc */
uint_t px_dvma_vmem_xfree = 0; /* vmem xfree */
uint_t px_dvma_vmem_free = 0; /* vmem free */
#endif
uint_t px_disable_fdvma = 0;
uint_t px_mmu_ctx_lock_failure = 0;
uint_t px_max_msiq_msgs = 4;
uint_t px_min_msiq_msgs = 2;
/*
* memory callback list id callback list for kmem_alloc failure clients
*/
uintptr_t px_kmem_clid = 0;
/* timeout in micro seconds for receiving PME_To_ACK */
uint64_t px_pme_to_ack_timeout = PX_PME_TO_ACK_TIMEOUT;
/* timeout in micro seconds for receiving link up interrupt */
uint64_t px_lup_poll_to = PX_LUP_POLL_TO;
uint64_t px_lup_poll_interval = PX_LUP_POLL_INTERVAL;
/* PIL at which PME_To_ACK message interrupt is handled */
uint32_t px_pwr_pil = PX_PWR_PIL;
uint32_t px_max_l1_tries = PX_MAX_L1_TRIES;
/* Print and Log tunables. The following variables are booleans */
#ifdef DEBUG
uint32_t px_log = PX_PANIC | PX_NO_PANIC | PX_PROTECTED | PX_HW_RESET;
#else
uint32_t px_log = PX_PANIC;
#endif
uint32_t px_die = PX_PANIC | PX_PROTECTED | PX_HW_RESET;