/*
* CDDL HEADER START
*
* The contents of this file are subject to the terms of the
* Common Development and Distribution License (the "License").
* You may not use this file except in compliance with the License.
*
* You can obtain a copy of the license at usr/src/OPENSOLARIS.LICENSE
* or http://www.opensolaris.org/os/licensing.
* See the License for the specific language governing permissions
* and limitations under the License.
*
* When distributing Covered Code, include this CDDL HEADER in each
* file and include the License file at usr/src/OPENSOLARIS.LICENSE.
* If applicable, add the following below this CDDL HEADER, with the
* fields enclosed by brackets "[]" replaced with your own identifying
* information: Portions Copyright [yyyy] [name of copyright owner]
*
* CDDL HEADER END
*/
/*
* Copyright 2009 Sun Microsystems, Inc. All rights reserved.
* Use is subject to license terms.
*/
#ifndef _SATA_SATL_H
#define _SATA_SATL_H
#include <sys/scsi/impl/spc3_types.h>
#ifdef __cplusplus
extern "C" {
#endif
/*
* Definitions and declarations
* ANSI SCSI / ATA Translation - 2 (SAT-2) specification
*/
/*
* SATL ATA Pass Through PROTOCOL field values
*/
#define SATL_APT_P_HW_RESET 0 /* ATA hardware reset */
#define SATL_APT_P_SRST 0x1 /* Software reset */
#define SATL_APT_P_NON_DATA 0x3 /* Non-data */
#define SATL_APT_P_PIO_DATA_IN 0x4 /* PIO Data-in */
#define SATL_APT_P_PIO_DATA_OUT 0x5 /* PIO Data-out */
#define SATL_APT_P_DMA 0x6 /* DMA */
#define SATL_APT_P_DMA_QUEUED 0x7 /* DMA Queued */
#define SATL_APT_P_DEV_DIAG 0x8 /* Device Diagnostics */
#define SATL_APT_P_DEV_RESET 0x9 /* Device Reset */
#define SATL_APT_P_UDMA_IN 0xa /* UDMA Data In */
#define SATL_APT_P_UDMA_OUT 0xb /* UDMA Data Out */
#define SATL_APT_P_FPDMA 0xc /* FPDMA */
#define SATL_APT_P_RET_RESP 0xf /* Return Response Info */
/*
* SATL ATA Pass Through bit masks
*/
#define SATL_APT_BM_EXTEND 0x01
#define SATL_APT_BM_CK_COND 0x20
#define SATL_APT_BM_T_DIR 0x08
#define SATL_APT_BM_BYTE_BLOCK 0x04
#ifdef __cplusplus
}
#endif
#endif /* _SATA_SATL_H */