/*
* CDDL HEADER START
*
* The contents of this file are subject to the terms of the
* Common Development and Distribution License, Version 1.0 only
* (the "License"). You may not use this file except in compliance
* with the License.
*
* You can obtain a copy of the license at usr/src/OPENSOLARIS.LICENSE
* See the License for the specific language governing permissions
* and limitations under the License.
*
* When distributing Covered Code, include this CDDL HEADER in each
* file and include the License file at usr/src/OPENSOLARIS.LICENSE.
* If applicable, add the following below this CDDL HEADER, with the
* fields enclosed by brackets "[]" replaced with your own identifying
* information: Portions Copyright [yyyy] [name of copyright owner]
*
* CDDL HEADER END
*/
/*
* Copyright (c) 1999-2000 by Sun Microsystems, Inc.
* All rights reserved.
*/
#pragma ident "%Z%%M% %I% %E% SMI"
/*
* Sun Microsystems RIO chipset
* See the RIO specification (r1.0), section 5.9, for a description
* of the vendor specific registers.
*/
#ifdef __cplusplus
extern "C" {
#endif
/*
* RIO's vendor specific register mapping information. What register set it
*/
/*
* For RIO pass 1, we will setup the GUID in as part of the vendor specific
* init. This is to support the RIO PPX card (since it does not have firmware
* to setup the GUID.
*/
/*
* RIO vendor specific registers. These are the offsets of the registers. They
* should be used as paramteres to hci1394_vendor_reg_write() and
* hci1394_vendor_reg_read().
*/
/* RIO interrupt event & mask bit offsets */
/* dma_burst_size (field defs) */
#define RIOREG_INF_BURST_SHIFT 0
/* dma_burst_size (values) */
/* xmit ctrl (field defs) */
#define RIOREG_XMIT_BND1_SHIFT 0
/* host control (field defs) */
/* Allow Descriptor pre-fetching */
#define RIOREG_HOST_CONTROL_SETTING \
/* stats_retries (field defs) */
/* stats_errors (field defs) */
/* stats_phys (field defs) */
#ifdef __cplusplus
}
#endif
#endif /* _SYS_1394_ADAPTERS_HCI1394_RIO_REGS_H */