Makefile revision 3789
# The contents of this file are subject to the terms of the # Common Development and Distribution License (the "License"). # You may not use this file except in compliance with the License. # See the License for the specific language governing permissions # and limitations under the License. # When distributing Covered Code, include this CDDL HEADER in each # If applicable, add the following below this CDDL HEADER, with the # fields enclosed by brackets "[]" replaced with your own identifying # information: Portions Copyright [yyyy] [name of copyright owner] # Copyright (c) 2011, 2014, Oracle and/or its affiliates. All rights reserved. # Need to preserve timestamp for Grammar files. If the pickle files are older, # Python will try to rebuild them. # We patch auto* files, so regenerate headers and configure # The DTrace patch needs this file to be mode 0755. # we don't want to leak $(CC_BITS) into BASECFLAGS as it causes problems with # to find the ncurses headers # enable large files how they did in JDS # because python links with $(CC) ... $(LDFLAGS) ... # The python build is profile-guided for studio; to see the benefits of that, # Python must be compiled with -xO5 and a different build target must be used. # Use of xprofile requires that the same options be used during compilation and # linking. The targets chosen are based on Solaris 11 minimum supported system # Python puts its header files in a special place. # Some tests have non-ASCII characters encoded for international domain names; # the publish step will fail in 'pkgdepend generate' without this: # 64 bit shared objects need to go in a 64-bit directory # Simplify the definitions of CC, CXX, CFLAGS and LDFLAGS so they hard-code # neither paths from our build systems nor Studio-specific options. $(GSED) -i -e 's/^CC=.*/CC=\t\tcc/' -e 's/^CXX=.*/CXX=\t\tCC/' \ -e 's/^CFLAGS=.*/CFLAGS=\t\t\$$\(BASECFLAGS) \$$\(OPT) \$$\(EXTRA_CFLAGS)/' \ # Because we stripped the Makefile above, we need to pass several things in the # environment, and use -e to tell gmake to pay attention to the environment. $(GSED) -i -e 's|$(SOURCE_DIR)|.|g' -e 's|$(COMPONENT_DIR)|..|g' \ # Using "-uall,-network" ensures all tests are run except the network tests. # The network tests contain many expected failures when run behind a firewall. # The "-v" ensures verbose mode. You can set TESTOPTS_PYTHON_TEST to a # particular test if you want to run just one test. For example, # $ TESTOPTS_PYTHON_TEST=test_sys gmake -k test # Note that when a test succeeds, the builds/*/.tested file gets created. You # may need to remove these files, or run "gmake clobber" or "gmake clean" # Prevent the tests from getting stuck waiting for input.