Makefile revision 695
#
# CDDL HEADER START
#
# The contents of this file are subject to the terms of the
# Common Development and Distribution License (the "License").
# You may not use this file except in compliance with the License.
#
# You can obtain a copy of the license at usr/src/OPENSOLARIS.LICENSE
# See the License for the specific language governing permissions
# and limitations under the License.
#
# When distributing Covered Code, include this CDDL HEADER in each
# file and include the License file at usr/src/OPENSOLARIS.LICENSE.
# If applicable, add the following below this CDDL HEADER, with the
# fields enclosed by brackets "[]" replaced with your own identifying
# information: Portions Copyright [yyyy] [name of copyright owner]
#
# CDDL HEADER END
#
#
#
# This component is not to be installed. It is used from openssl-0.9.8-fips-140
# to build FIPS-140 certified OpenSSL libraries.
#
COMPONENT_VERSION = 1.2
# In order to build a 32bit version on a 64bit system the isalist(1) command
# must be substituted for the 32bit build so that amd64|sparcv9 is not part of
# its output. isalist is used internally when configuring the canister before
# building it. In order to allow make install to be run as a no-op we have to
# fake "make install" since we do not want to install the files anywhere. The
# command sets U1 and U2 are defined in the FIPS 1.2 security policy and must be
# run as shown there. Nothing from the tarball can be modified. We use the U2
# command set, see below.
# Do not use $(PWD), it would not work if run from a different directory with
# "gmake -C" as we do from openssl-0.9.8-fips-140.
FIPS_PATH_64 = $(PATH)
# There is a broken link in the tarball which causes cp(1) to fail which would
# fail the whole configure process. It's safer to get rid of the link than
# adding "true" at the end of COMPONENT_PRE_CONFIGURE_ACTION since that could
# hide real issues.
# There is a specific way that must be followed to build the FIPS-140 canister.
# It is "./config fipscanisterbuild; make; make install" and is called a command
# set "U2" in the OpenSSL FIPS-140 User Guide.
# Add COMPONENT_DIR to PATH so cc wrapper can be found.
$(BUILD_32_and_64): $(FAKE_APPS)
# You should not use this target with this component unless testing or
# debugging. The OpenSSL FIPS-140 policy is strict and full U2 command set
# should be run. See above for more information.
build: $(BUILD_32_and_64)
# We must make the "install" target a no-op (but must run it to be compliant).
# See above for more information.
# This is a recommended set of commands to verify that the FIPS-140 mode can be
# used and that we used the correct tarball.
(printf x; \
$(NAWK) '{ if ($$2 != "$(OPENSSL_FIPS_HMAC)") exit 1 }'
$(TOUCH) $@
test: $(NO_TESTS)