Makefile revision 2887
# The contents of this file are subject to the terms of the # Common Development and Distribution License (the "License"). # You may not use this file except in compliance with the License. # See the License for the specific language governing permissions # and limitations under the License. # When distributing Covered Code, include this CDDL HEADER in each # If applicable, add the following below this CDDL HEADER, with the # fields enclosed by brackets "[]" replaced with your own identifying # information: Portions Copyright [yyyy] [name of copyright owner] # Copyright (c) 2011, 2014, Oracle and/or its affiliates. All rights reserved. # This component is not to be installed. It is used to build FIPS-140 # certified OpenSSL libraries. # In order to build a 32bit version on a 64bit system the isalist(1) command # must be substituted for the 32bit build so that amd64|sparcv9 is not part of # its output. isalist is used internally when configuring the canister before # building it. In order to allow make install to be run as a no-op we have to # fake "make install" since we do not want to install the files anywhere. The # command sets U1 and U2 are defined in the FIPS 2.0.5 security policy and must be # run as shown there. Nothing from the tarball can be modified. We use the U2 # command set, see below. # Do not use $(PWD), it would not work if run from a different directory with # "gmake -C" as we do from openssl-1.0.1 # we'll also pick up gcc if we find it in the path, so force it to # find one that doesn't work like it wants # There is a broken link in the tarball which causes cp(1) to fail which would # fail the whole configure process. It's safer to get rid of the link than # adding "true" at the end of COMPONENT_PRE_CONFIGURE_ACTION since that could # There is a specific way that must be followed to build the FIPS-140 canister. # It is "./config fipscanisterbuild; make; make install" and is called a command # set "U2" in the OpenSSL FIPS-140 User Guide. # For 64-bit, use './Configure fipscanisterbuild solaris64-sparcv9-cc'. # Add COMPONENT_DIR to PATH so cc wrapper can be found. # You should not use this target with this component unless testing or # debugging. The OpenSSL FIPS-140 policy is strict and full U2 command set # should be run. See above for more information. # We must make the "install" target a no-op (but must run it to be compliant). # See above for more information. # This is a recommended set of commands to verify that the FIPS-140 mode can be # used and that we used the correct tarball. $(NAWK) '{ if ($$2 != "$(OPENSSL_FIPS_HMAC)") exit 1 }'