libses.h revision 2
2N/A * The contents of this file are subject to the terms of the 2N/A * Common Development and Distribution License (the "License"). 2N/A * You may not use this file except in compliance with the License. 2N/A * See the License for the specific language governing permissions 2N/A * and limitations under the License. 2N/A * When distributing Covered Code, include this CDDL HEADER in each 2N/A * If applicable, add the following below this CDDL HEADER, with the 2N/A * fields enclosed by brackets "[]" replaced with your own identifying 2N/A * information: Portions Copyright [yyyy] [name of copyright owner] 2N/A * Copyright (c) 2008, 2012, Oracle and/or its affiliates. All rights reserved. 2N/A * These are properties attached to the root target node of the enclosure, and 2N/A * represent the SCSI inquiry data. 2N/A * This property provides a human-readable name for the element type. This is 2N/A * constant, and not derived from the enclosure data. 2N/A * The following properties can be added to any node. There is no provision in 2N/A * the specification for these properties, but they can be derived from vendor 2N/A * specific data for some enclosures. 2N/A * The chassis serial number is a pseudo property that doesn't exist in SES 2N/A * spec. A single physical chassis may present several logically different SES 2N/A * targets that are connected to the same or different elements. These targets 2N/A * can extract the chassis serial number in a vendor-specific way so that 2N/A * consumers know these SES targets refer to the same device. This defaults to 2N/A * to the logical-id, and is always present. 2N/A * This boolean property identifies a chassis as internal, where the connected 2N/A * elements are part of a single system chassis and not an external enclosure. 2N/A * This is used on platforms with a disk backplane that exports a SES target. 2N/A * This property identifies the subchassis id for those systems that 2N/A * support the concept of a subchassis. 2N/A * Maximum allowed firmware upload chunk size. Obtained in a vendor- or 2N/A * platform-specific manner but generic in nature. 2N/A * This property indicates if fault management on the enclosure is externally 2N/A * managed. If it is the host connecected to the enclosure diagnoses a fault 2N/A * and determines the element status. 2N/A * The host FMA may or may not manage the service LED of a component in such 2N/A * This property indicates if service LED is managed by the enclosure. 2N/A * It is set for a component that the enclosure self manages the service LED 2N/A * when a fault is detected. 2N/A * This property indicates that the enclosure reads sensors and reports 2N/A * out of range reading to the host through an enclosure specific way. 2N/A * The host FMA can check this property and avoid duplicate error reporting 2N/A * on sensors for the entire enclosure. 2N/A * When the enclosure self-reports a subset of sensors so 2N/A * LIBSES_EN_PROP_SENSOR_SELF_REPORTED can not be set at the enclosure level 2N/A * another property like "libses-elem-sensor-self-reported" can be used for 2N/A * those SES eleements that the sensor reading is self-reported. 2N/A * Currently no such support is needed. 2N/A#
endif /* _FRAMEWORK_LIBSES_H */