pciide.h revision 507c32411f3f101e90ca2120f042b5ee698ba1d5
/*
* CDDL HEADER START
*
* The contents of this file are subject to the terms of the
* Common Development and Distribution License (the "License").
* You may not use this file except in compliance with the License.
*
* You can obtain a copy of the license at usr/src/OPENSOLARIS.LICENSE
* or http://www.opensolaris.org/os/licensing.
* See the License for the specific language governing permissions
* and limitations under the License.
*
* When distributing Covered Code, include this CDDL HEADER in each
* file and include the License file at usr/src/OPENSOLARIS.LICENSE.
* If applicable, add the following below this CDDL HEADER, with the
* fields enclosed by brackets "[]" replaced with your own identifying
* information: Portions Copyright [yyyy] [name of copyright owner]
*
* CDDL HEADER END
*/
/*
* Copyright 2004 Sun Microsystems, Inc. All rights reserved.
* Use is subject to license terms.
*/
#ifndef _PCIIDE_H
#define _PCIIDE_H
#pragma ident "%Z%%M% %I% %E% SMI"
#ifdef __cplusplus
extern "C" {
#endif
/*
* Bus Mastering devices have a PCI class-code of 0x010180 to 0x0101ff
*/
#define PCIIDE_BM_CAP_MASK 0x80
#define PCIIDE_BM_CLASS ((PCI_CLASS_MASS << 16) | (PCI_MASS_IDE << 8) | 0x80)
#define PCIIDE_BM_CLASS_MASK 0xffffff80
#define PCIIDE_BMICX_REG 0 /* Bus Master IDE Command Register */
#define PCIIDE_BMICX_SSBM 0x01 /* Start/Stop Bus Master */
#define PCIIDE_BMICX_SSBM_E 0x01 /* 1=Start (Enable) */
/* 0=Start (Disable) */
/*
* NOTE: "read" and "write" are the actions of the DMA
* engine on the PCI bus. Not the DMA engine's action on the ATA
* BUS. Therefore for a ATA READ command, program the DMA engine to
* "write to memory" mode (and vice versa).
*/
#define PCIIDE_BMICX_RWCON 0x08 /* Read/Write Control */
#define PCIIDE_BMICX_RWCON_WRITE_TO_MEMORY 0x08 /* 1=Write (dev to host) */
#define PCIIDE_BMICX_RWCON_READ_FROM_MEMORY 0x00 /* 0=Read (host to dev) */
/* preserve these bits during updates */
#define PCIIDE_BMICX_MASK (~(PCIIDE_BMICX_SSBM | PCIIDE_BMICX_RWCON))
#define PCIIDE_BMISX_REG 2 /* Bus Master IDE Status Register */
#define PCIIDE_BMISX_BMIDEA 0x01 /* Bus Master IDE Active */
#define PCIIDE_BMISX_IDERR 0x02 /* IDE DMA Error */
#define PCIIDE_BMISX_IDEINTS 0x04 /* IDE Interrupt Status */
#define PCIIDE_BMISX_DMA0CAP 0x20 /* Drive 0 DMA Capable */
#define PCIIDE_BMISX_DMA1CAP 0x40 /* Drive 1 DMA Capable */
#define PCIIDE_BMISX_SIMPLEX 0x80 /* Simplex only */
/* preserve these bits during updates */
#define PCIIDE_BMISX_MASK 0xf8
#define PCIIDE_BMIDTPX_REG 4 /* Bus Master IDE Desc. Table Ptr */
#define PCIIDE_BMIDTPX_MASK 0x00000003 /* must be zeros */
typedef struct PhysicalRegionDescriptorTableEntry {
uint_t p_address; /* physical address */
uint_t p_count; /* byte count, EOT in high order bit */
} prde_t;
/*
* Some specs say the p_address must 32-bit aligned, and some claim
* 16-bit alignment. Use 32-bit alignment just to be safe.
*/
#ifdef __not_yet__
#define PCIIDE_PRDE_ADDR_MASK ((uint_t)(sizeof (short) -1))
#else
#define PCIIDE_PRDE_ADDR_MASK ((uint_t)(sizeof (int) -1))
#endif
#define PCIIDE_PRDE_CNT_MASK ((uint_t)0x0001) /* must be even */
#define PCIIDE_PRDE_CNT_MAX ((uint_t)0x10000) /* 0 == 64k */
#define PCIIDE_PRDE_EOT ((uint_t)0x80000000)
#ifdef __cplusplus
}
#endif
#endif /* _PCIIDE_H */