ixgbe.conf revision da14cebe459d3275048785f25bd869cb09b5307f
# The contents of this file are subject to the terms of the # Common Development and Distribution License (the "License"). # You may not use this file except in compliance with the License. # See the License for the specific language governing permissions # and limitations under the License. # When distributing Covered Code, include this CDDL HEADER in each # If applicable, add the following below this CDDL HEADER, with the # fields enclosed by brackets "[]" replaced with your own identifying # information: Portions Copyright [yyyy] [name of copyright owner] # Copyright(c) 2007-2008 Intel Corporation. All rights reserved. # Copyright 2008 Sun Microsystems, Inc. All rights reserved. # Use is subject to license terms. # Driver.conf file for Intel 10GbE PCIE NIC Driver (ixgbe) # -------------------- Jumbo Frame -------------------- # The size of the default MTU (payload without the ethernet header) # Allowed values: 1500 - 16366 # -------------------- Flow Control -------------------- # Allowed values: 0 - Disable # 3 - Receive and transmit # The number of the transmit descriptors per transmit queue # Allowed values: 64 - 4096 # The number of the receive descriptors per receive queue # Allowed values: 64 - 4096 # Enable multiple tx queues and rx queues # The number of the receive groups # -------- How to set parameters for a particular interface --------- # The example below shows how to locate the device path and set a parameter # for a particular ixgbe interface. (Using flow_control as an example) # Use the following command to find out the device paths for ixgbe, # For example, if you see, # "/pci@7b,0/pci10de,5d@e/pci8086,a15f@0" 0 "ixgbe" # "/pci@7b,0/pci10de,5d@e/pci8086,a15f@0,1" 1 "ixgbe" # name = "pciex8086,10c6" parent = "/pci@0,0/pci10de,\<pci10de\>5d@e" unit-address = "0" # name = "pciex8086,10c6" parent = "/pci@0,0/\<pci\>pci10de,5d@e" unit-address = "1"