Lines Matching defs:table
98 * TFDB Area - TFDs buffer table
218 * TAGR Area - TAG reconstruct table
586 * CBB table
718 * The driver must maintain the queue's Byte Count table in host DRAM
728 * This mode does not require use of the Byte Count table in host DRAM.
942 * 8-4: Index into device's station table for recipient station
1643 * Driver should interpolate factory values for temperature, gain table
1652 * factory-measured txpower. Using (interpolated) factory gain table index
1655 * Each step in the gain table is 1/2 dB.
1668 * increase gain (lower gain table index), and vice versa.
1687 * voltage, gain should be reduced (gain table index increased) by:
1692 * voltage, gain should be increased (gain table index decreased) by:
1703 * compensation for txpower (number of steps in gain table)
1738 * 10) Select the gain table, based on band (2.4 vs 5 GHz).
1740 * Limit the adjusted index to stay within the table!
1743 * 11) Read gain table entries for DSP and radio gain, place into appropriate
1789 * The value "6" represents number of steps in gain table to reduce power.
1810 * back off gain by adding these values to the gain table index.
1844 * driver work with the same table).
1846 * There are separate tables for 2.4 GHz and 5 GHz bands. The 5 GHz table
1850 * corresponds to the 49th entry in the table used by the driver.
1862 * 2.4 GHz gain table
1967 * 5 GHz gain table
2132 * Number of entries in the gain table
2178 * in table below. If current temperature is lower than factory, driver must
2437 * Byte Count table
2439 * Each Tx queue uses a byte-count table containing 320 entries:
2446 * count table for the chosen Tx queue. If the TFD index is 0-63, the driver
2449 * "dont_care" padding puts each byte count table on a 1024-byte boundary;
2856 * Param table within SENSITIVITY_CMD
2872 uint16_t table[HD_TABLE_SIZE];