Lines Matching defs:table
237 * Driver should interpolate factory values for temperature, gain table
246 * factory-measured txpower. Using (interpolated) factory gain table index
249 * Each step in the gain table is 1/2 dB.
262 * increase gain (lower gain table index), and vice versa.
281 * voltage, gain should be reduced (gain table index increased) by:
286 * voltage, gain should be increased (gain table index decreased) by:
297 * compensation for txpower (number of steps in gain table)
332 * 10) Select the gain table, based on band (2.4 vs 5 GHz).
334 * Limit the adjusted index to stay within the table!
337 * 11) Read gain table entries for DSP and radio gain, place into appropriate
392 * The value "6" represents number of steps in gain table to reduce power.
402 * back off gain by adding these values to the gain table index.
429 * driver work with the same table).
431 * There are separate tables for 2.4 GHz and 5 GHz bands. The 5 GHz table
435 * corresponds to the 49th entry in the table used by the driver.
446 /* 5.2GHz power gain index table */
557 /* 2.4GHz power gain index table */
959 * For OFDM, adjust the following table entries in struct iwk_rx_sensitivity_cmd
971 * by *adding* 1 to all 4 of the table entries above, up to the max for
1000 * Then, adjust the following CCK table entries in struct iwk_rx_sensitivity_cmd
1095 uint16_t table[11];