Lines Matching defs:read
196 * otherwise assume the read PHY ID is correct if it is valid.
360 * attempts to acknowledge any phy read requests.
414 * that the PHY is in a known good state before we read/write
661 /* Can't read flash registers if register set isn't mapped. */
705 nvm->ops.read = e1000_read_nvm_spt;
708 nvm->ops.read = e1000_read_nvm_ich8lan;
837 * @data: pointer to value to read/write from/to the EMI address
838 * @read: boolean flag to indicate read or write
843 u16 *data, bool read)
853 if (read)
867 * @data: value to be read from the EMI address
1540 * change in link status has been detected, then we read the PHY registers
1964 * This is a function pointer entry point only called by read/write
1985 * This is a function pointer entry point only called by read/write
2354 ret_val = hw->nvm.ops.read(hw, (word_addr + i * 2), 1,
2359 ret_val = hw->nvm.ops.read(hw, (word_addr + i * 2 + 1),
3418 /* set bank to 0 in case flash read fails */
3463 /* set bank to 0 in case flash read fails */
3497 * @offset: The offset (in bytes) of the word(s) to read.
3498 * @words: Size of data to read in words.
3499 * @data: pointer to the word(s) to read at offset.
3582 DEBUGOUT1("NVM read error: %d\n", ret_val);
3590 * @offset: The offset (in bytes) of the word(s) to read.
3591 * @words: Size of data to read in words
3592 * @data: Pointer to the word(s) to read at offset.
3644 DEBUGOUT1("NVM read error: %d\n", ret_val);
3653 * This function does initial flash setup so that a new read/write/erase cycle
3736 * e1000_flash_cycle_ich8lan - Starts flash cycle (read/write/erase)
3784 * to bytes before read.
3807 * to bytes before read.
3826 * @offset: The offset of the byte to read.
3827 * @data: Pointer to a byte to store the value read.
3856 * @offset: The offset (in bytes) of the byte or word to read.
3857 * @size: Size of data to read, 1=byte 2=word
3858 * @data: Pointer to the word to store the value read.
3898 * read in (shift in) the Flash Data0, the order is
3932 * @offset: The offset (in bytes) of the dword to read.
3933 * @data: Pointer to the dword to store the value read.
3980 * read in (shift in) the Flash Data0, the order is
4155 /*offset in words but we read dword*/
4175 /* offset in words but we read dword*/
4399 ret_val = hw->nvm.ops.read(hw, word, 1, &data);
4419 * @offset: The offset (in bytes) of the byte/word to read.
4420 * @size: Size of data to read, 1=byte 2=word
4517 * @offset: The offset (in bytes) of the dwords to read.
4606 * @offset: The index of the byte to read.
4827 ret_val = hw->nvm.ops.read(hw, NVM_ID_LED_SETTINGS, 1, data);
4957 * on the last TLP read/write transaction when MAC is reset.
5136 /* Clear all of the statistics registers (clear on read). It is
5469 /* read once to clear */
5533 * 3) read it back
5981 * NOTE: some silicon which is EEPROM-less will fail trying to read the
6002 /* When auto config read does not complete, do not