Lines Matching refs:mode
64 * DMFE_DMA_MODE defines the mode (STREAMING/CONSISTENT) used for
66 * mode.
77 * dmfe_bus_modes: the bus mode bits to be put into CSR0.
96 * The default hardware packet filtering mode is now
101 * HASH_ONLY mode (imperfect filtering of *all* packets).
340 * dmfe_set_opmode() -- function to set operating mode
482 dmfe_start_chip(dmfe_t *dmfep, int mode)
486 dmfep->opmode |= mode;
491 * Enable VLAN length mode (allows packets to be 4 bytes Longer).
499 dmfep->chip_state = mode & START_RECEIVE ? CHIP_TX_RX :
500 mode & START_TRANSMIT ? CHIP_TX_ONLY : CHIP_STOPPED;
1334 * In this mode, *all* incoming addresses are hashed and looked
1340 * NOTE: in this mode, unicast packets that are not intended for
1345 * filtering. In this mode, multicast addresses are hashed and
1352 * Whichever mode we're using, we have to enter the broadcast
1557 * dmfe_m_promisc() -- set or reset promiscuous mode on the board
2091 uint32_t mode;
2124 if (iocp->ioc_count != sizeof (mode)) {
2130 mode = 0;
2133 mode = 1;
2136 mode = 2;
2140 bcopy(&mode, mp->b_cont->b_rptr, sizeof (mode));
2148 if (iocp->ioc_count != sizeof (mode)) {
2152 bcopy(mp->b_cont->b_rptr, &mode, sizeof (mode));
2156 switch (mode) {